Car Driver's Tips for Save the Fuel Cost


Car Driver's  tips for save the fuel cost

 

Fuel cost is mojor cost of every vehicle so car driver or owner should follow some impotant instruction that is helpful for saving fuel cost. The important tips are follows:


If the radiator heat is higher it means the radiator is not functioning properly and is not cooling. If you do not repair immediately, there may be various damage. To check adjustment distributor. If not, the fuel cost will be more.

 

There is no break, no gear etc. If there is no instrument, it should be repaired immediately. It is absolutely necessary to repair it immediately.

 

Due to the high occupancy of cars, it means that the damage to the gear and the fuel is severe. Immediately it will be repaired - if not, danger and bad costs, then it will be remembered.

 

The noise of the wheels of the vehicle is more than the noise, if you do not repair it immediately, you will be forced to pay petrol bills.

 

The car is another major vehicle car wheel. Meanwhile, keep the ninja all the time. Between two front and two rear wheels, from the full parallel. If it does not, or if it is loosened, it will not shake the vehicle unnecessarily. Cars shake all the time to spend more on petrol.

 

Whether the wheels of the wheels are bearable and whether it is properly wrinkle and if there is a noise, then all other things in the car may be good, but the car can be unnecessarily junky. Its polished is okay. Otherwise, you will lose some mile of pap liter liter.

 

It should always be seen that the stagnant nuts are okay and they are well kept. If it does not, ginger speed will not be properly. If you run lazily, you will not have to speed up the speed of your vehicle. Sometimes it will be used to drive the car, so that the waste of oil will be used.

 

Crown and Tail Do not have any teeth in Pinyin, so keep an eye on it. Because maybe it appears that the car is normal all the way, but the crown or the tail pinion has broken the teeth to keep the vehicle shaking unnecessarily. As soon as this is done, it will have to be repaired immediately. When you are in a car garage, check it out properly, if any of its teeth are broken.

 

Tail brearing is always good. Many times it may get dirty due to it. Due to this, due to the dirt in it, it will be a bit thicker and therefore the car will run properly, but the car may shiver or jhub sometimes. So the tel birring should be cleaned regularly. If there is a doubt that it is not working properly, then check the car entering the garage and make it clean. If you think that all these checkups should be cleaned once per month. If the beer's lubrication is not good then it has to be lubricated. 

Crown and tail adjustment should be well-noticed. If there is a slight noise in this adjustment, the car can sometimes shake. As a result, oil costs will be high.

 

All the time 'When you leave the house, take a different look from where you are going next. If you do not, then you may have to travel around doing some specific work. In today's era the excess of petrol that is wrong, you must be convinced.

 

If it is not necessary, then you should avoid long jarreni. If there are benefits and should avoid the long journey in other ways. If there are advantages and in other ways long journals can be easily made, then if you want to avoid the long journey in vain as much as possible during the absence of today's oil.

 

At the end of this article we suggest that every three months, for a reason, whether there is reason or not, mechanical checking and servicing are needed, so many benefits can be found.

 



Latest Articles List

Fuel Type wise Motor Engine

Fuel type wise Motor Engine:  The internal combustion engine can be powered by a variety of fluids. That is Petrol or gasoline engine. Crude Oye or Semi Diesel. Diesel or compression EP3 engine.   This time, different types of engines are used, depending on the shape of the engine. J Type Engine: This type of engine looks a lot like English j's. This is because there are two inline ports and exhaust posts on both sides of the cylinder and the crank shaft. All together looks like the letter j - hence the name.   Photo: J type engineThe

Different Type of Car Motor Engine

Different Type of Car Motor Engine   Hello reader, today we want to write about different type of car engine for our all readers and car lovers. We all know that the engine is a motor-driven power supply. It is from this engine that the car gets the speed and the speed is driven by the machine with the speed of the car and the speed is driven by the machine with the speed of the wheel. Generally, most of the cars used in our country nowadays are international combustion engineered. However, they are discussed briefly, as they are necessary

Short Description about different type of Car Spring

Short Description about different type of Car Spring     A spring is an elastic object that stores mechanical energy. Springs are typically made of spring steel. There are many spring designs. In everyday use, the term often refers to coil springs. On the other hand, peeling of the group of stainless steel caps between Chess and Axil. The wheels are very low in the body, while the wheels are running very fast. The better the spring, the less pressure will be less. It's a little harder to pinpoint at this spring. But if you can do it properly then

Short Description of Wheel, Axle, Driving Shaft, Cross Rod, Tie rod and Crown Pinion

Short Description of Wheel, Axle, Driving Shaft, Cross Rod, Tie rod and Crown Pinion Hello readers today we want to discuss with you about some important parts of car like wheel, Axle, driving shaft, cross rod, tie rod, Crown pinion with short discription. We know Front-wheel drive (FWD) is a form of engine and transmission layout used in motor vehicles, where the engine drives the front wheels only. Most modern front-wheel-drive vehicles feature a transverse engine, rather than the conventional longitudinal engine arrangement generally found in rear-wheel-drive and four-wheel drive vehicles. In most of the vehicles, the wheel drives the

6 Tips for Reduce Fuel Cost

6 Tips for Reduce Fuel Cost   Car Start: when a driver starts a car, as soon as possible he starts with the flick, drive as high as possible gear. Because we know that gradually starting a car and using low gear fuel costs are high. If we start with high gear and start speeding, then the cost of fuel will decrease by 25 to 40 percent. Thus, every liter of fuel consumption will be reduced – you will go every mile with fewer burn the oil.  2.  Stop the specific place:For reduce fuel cost you decide first



Car Service and Information List

Fitness and Tax Token Collection Process from Road Transport Authority (BRTA) in Bangladesh

Fitness and Tax Token Collection Process from Road Transport Authority (BRTA) in Bangladesh  Dear all reader and viewers welcome to carpricebd.com. today we want to discuss with about Fitness and Tax Token received and renewal process from Bangladesh Road Transport Authority (BRTA). We all know that it essential for all kind of bus, minibus, and other motor car to collect route permit. BRTA have some rules, terms and condition for collecting Fitness and Tax Token from them.  So we requesting you all please go through carefully below process and collect yourFitness and Tax Token new or renewal

Route permit issue and renewal process from BRTA in Bangladesh

Route permit issue and renewal process from BRTA in Bangladesh   Dear all reader and viewers welcome to carpricebd.com. today we want to discuss with about route permit received and renewal process from Bangladesh Road Transport Authority (BRTA). We all know that it essential for all kind of bus, minibus, and other motor car to collect route permit. BRTA have some rules, terms and condition for collecting route permit from them.  So we requesting you all please go through carefully below process and collect your route permit new or renewal old one and collect hassle free route permit

How to collect a latest number plate from BRTA in Bangladesh

How to collect a latest number plate from BRTC in Bangladesh Introduction: Hello readers and viewers today we want to share with you the most important thing is vehicle number plate.  The latest number plate of a  vehicle is very important things to vehicle run in the road. For fulfillingnumber plate process related infomation we carpricebd.com team requesting you all please read carefully and do needful for car number plate collection process.   The latest number plate:   For the addition of digital number plate on the motor vehicle, the customer will have to apply at the concerned

Vehicle Ownership Transfer Process from BRTA in Bangladesh

Vehicle Ownership Transfer Process in Bangladesh Introduction: Hello readers, viewers today we want to share vehicle ownership transfer registration process that is very helpful who wants to transfer their ownership to others.For fulfilling vehicle ownership transfer process related infomation we carpricebd.com team requesting you all please read carefully and do needful for car ownership transfer process . Documents required for transfer of ownership (other than inherited ownership):Buyer to:    1. Completed and signed 'Tio' and 'TTO' forms; [Other forms with these two forms can be found on the website DOWNLOAD FORMS]    2. Required fee deposit

Motor Car and Vehicle Registration Process and Necessary Documentation From BRTA in Bangladesh

Motor car and vehicle registration process and necessary documentation from BRTA in Bangladesh   Introduction: Hello readers, viewers today we want to share vehicle registration process that is every car owner should require for car registration. We carpricebd.com team requesting you all please read carefully and do needful for car registration. The Car owner will apply for registration of his motor vehicle along with the required documents in the prescribed form at the concerned BRTA office. Subsequently, upon receipt of the verification by the BRTA office, his application and the relevant arguments are found to be correct, the